Vision-Guided Flange Fastening Machine for Rectangular Duct
Fixes angle flanges to rectangular duct with M4.2 x 19 fasteners, 13 axes, up to 3000 mm wide
Overview
What it does
On angle-flange ductwork, the flange frame is fastened to the duct wall all the way round. This machine does that job: the duct with its flanges sits on roller conveyors, a vision system guides the heads to each fastening point, and they drive M4.2 x 19 threaded fasteners through the flange into the duct wall.
It is set up by entering the duct size and starting point; 13 axes position the heads around the section. A fastener takes about 10 seconds.
It works on 1.5 mm galvanized duct with 30 x 30 x 3, 40 x 40 x 3 or 50 x 50 x 3 angle flanges, for ducts 500 to 3000 mm by 500 to 1500 mm and 300 to 1250 mm high.
Questions before you quote?
Send photos or drawings of your parts and we come back with the right configuration.
Ask on WhatsAppOptions to discuss
- Conveyor length to your duct sizes
- Flange profile set-up
What we need from you to quote
- Duct size range and wall thickness
- Flange profile and fastener spacing
- Ducts per shift
- Site power supply
Related machines in our duct range
- Four Gun Angle Iron Flange Welding Machine SB-FS1535L: welds angle iron flange frames for rectangular duct
Supply terms
Who supplies it. Taokron. We handle the inquiry, specification review, quotation, pre-shipment inspection, shipping and after-sales support from Melbourne.
Lead time. Lead time is not published for these machines. It depends on the configuration and is confirmed at quotation.
Warranty. Warranty terms are confirmed at quotation.
Commissioning. Remote support included; on-site installation engineer available on request, quoted per order.
CE. CE marking is confirmed at quotation for each machine.
Price. Each machine is configured to your parts, material and output, so there is no list price. Send your details and we quote that machine.
Price request
Ask for a quotation on this machine
Send the parts you make, the material and thickness, the size range and your output. Ryan Tao replies within 12 hours with a configuration, lead time and price. You can also send photos and drawings on WhatsApp +61 435 074 994.
Quotation for: Vision-Guided Flange Fastening Machine for Rectangular Duct
Several machines or a complete line? Use the full inquiry form
Frequently asked questions
About this machine
What does it fasten?
Angle flanges to rectangular duct, with M4.2 x 19 fasteners, on 1.5 mm galvanized duct.
How is it programmed?
You enter the duct specification and the starting point; the vision system guides the heads to the fastening points.
Is it used for TDF or TDC duct?
No. It is for angle-flange duct. For TDF duct, see the duct flange and corner machines in our duct range.
What lead time and warranty apply?
Lead time and warranty for this machine are confirmed in the quotation for your configuration.
Is the machine CE marked?
CE marking is confirmed at quotation. Tell us the destination country and we check what documents come with the machine.
Welding and cutting automation
